For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1335 03: Device Power 3 Circuit voltage below thresholdCircuit/System Description
The folding top control (FTC) module receives B+ on C 1, pin 26. The FTC Module monitors this circuit for proper operation.
Conditions for Running the DTC
The FTC module is active.
Conditions for Setting the DTC
Voltage is less than 8 volts when active, or 9 volts when inactive.
Action Taken When the DTC Sets
The top is disabled.
Conditions for Clearing the DTC
The fault is no longer present and the top completes one cycle.
Diagnostic Aids
A weak battery can cause DTC B1335 03 to set.
Reference Information
Schematic Reference
Description and Operation
Power Folding Top Description and Operation
Electrical Information Reference
Scan Tool Reference
Circuit/System Testing
- Disconnect the battery positive voltage circuit C 1, pin 26.
- Test for more than 9 volts at the battery positive voltage circuit.
- If circuit tests OK, replace the FTC Module.
| ⇒ | If circuit is less than 9 volts, test for an open, high resistance, or short to ground. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
