GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 22610 Keystone Clamp Pliers.

Disassembly Procedure


    Object Number: 297360  Size: SH
  1. To remove the outer tie rod. Refer to Rack and Pinion Outer Tie Rod End Replacement .
  2. Remove the hexagon jam nut (2) from the inner tie rod assembly (1).

  3. Object Number: 416130  Size: SH
  4. Remove the tie rod end clamp (2) from the rack and pinion boot (1).

  5. Object Number: 416133  Size: SH
  6. Remove the boot clamp (1) from the rack and pinion boot with side cutters.
  7. Discard the boot clamp (1).

  8. Object Number: 416160  Size: SH

    Important: 

       • If a breather tube is present, mark the location of the breather tube on the gear assembly before removal of the rack and pinion boot.
       • After removing the boot, inspect the inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear.

  9. Remove the rack and pinion boot (1) and the breather tube, if present, from the rack and pinion gear assembly.

Assembly Procedure


    Object Number: 416133  Size: SH
  1. Install the new boot clamp (1) onto the rack and pinion boot (3).

  2. Object Number: 416140  Size: SH
  3. Prior to rack and pinion boot installation, apply grease to the inner tie rod assembly (2) and the rack and pinion gear assembly (1).
  4. Install the rack and pinion boot (3) onto the inner tie rod assembly (2).
  5. If present, install the breather tube while aligning the breather tube with the mark made during removal and the molded nipple of the rack and pinion boot.
  6. Important: The rack and pinion boot (3) must not be twisted, puckered or out of shape in any way. If the rack and pinion boot (3) is not shaped properly, adjust the rack and pinion boot (3) by hand before installing the boot clamp.

  7. Install the rack and pinion boot onto the gear assembly (1) until the rack and pinion boot (3) is seated in the gear assembly groove.

  8. Object Number: 416163  Size: SH
  9. Install the boot clamp (1) on the rack and pinion boot (2) with J 22610 .
  10. Crimp the boot clamp (1).
  11. Pinch the pliers together on the rack and pinion boot (2) in order to install the tie rod end clamp.

  12. Object Number: 416130  Size: SH
  13. Install the tie rod end clamp (2) onto the rack and pinion boot (1).

  14. Object Number: 297638  Size: SH
  15. Install the hexagon jam nut (2) to the inner tie rod assembly (1).
  16. To assemble the outer tie rod assembly. Refer to Rack and Pinion Outer Tie Rod End Replacement .