1

Driven Sprocket Thrust Washer

2

Drive Sprocket Thrust Washer

3

Install Drive Link Assembly

Tip
Install as an assembly.

4

A/Trans Fluid Pump Assembly

Tip
Rotating the drive sprocket and link assembly while installing the oil pump will aid in aligning the driven sprocket and oil pump drive shaft splines.

5

A/Trans Fluid Pump Bolt M6 x 25 (Qty: 3)

Notice: Refer to Fastener Notice in the Preface section.

Procedure:

Tighten in sequence shown.

Tighten
12 N·m (106 lb in).

1

Drive Sprocket Thrust Washer

2

Front Differential Transfer Drive Gear Support Assembly

3

Front Differential Transfer Drive Gear Support Bolt M8 x 25 (Qty: 10)

Notice: Refer to Fastener Notice in the Preface section.

Procedure

Tighten in sequence shown.

Tighten
10 N·m (89 lb in) plus 50 degrees +/- 4 degrees.

Special Tools:

J 45059 Angle Meter

4

Front Differential Carrier Baffle

5

Front Differential Carrier Baffle Bolt M6 x 25

Tighten
12 N·m (106 lb in).