Tools Required

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the drive axle assembly. Refer to Wheel Drive Shaft Replacement .



3. Use a medium screwdriver and a mallet in order to remove the case cover seal.



4. Remove the drive axle retaining clip from the output axle.



5. Use the J 41227 in order to remove the sleeve from the output axle shaft.
6. Clean and inspect the seal bore.
7. Use fine sand paper in order to remove any burrs or nicks. Clean the entire area after any sanding.

1. Use the J 41102-1A and a mallet in order to install the new case cover seal.



2. Use the J 41228 in order to install a new sleeve on the output axle. Install the J 41228 so that the collar is in the snap ring groove.



3. Install the axle shaft retaining clip onto the output axle.
4. Install the drive axle assembly. Refer to Wheel Drive Shaft Replacement .
5. Lower the vehicle.
6. Inspect the shaft sleeve for leaks.
7. Inspect the transmission oil level. Refer to Transmission Fluid Check .