GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2007 🢒 G6 🢒 Body Systems 🢒 Adjustable Pedals 🢒 Accelerator Pedal Assembly Replacement

Removal Procedure
  1. Disconnect the accelerator pedal position sensor electrical connector.
  2. Remove the accelerator mounting nuts from the accelerator bracket.
  3. Remove the accelerator assembly from the vehicle.

Installation Procedure
  1. Install the accelerator assembly to the vehicle.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the accelerator mounting nuts to the accelerator bracket.

    3. Tighten
    Tighten the nuts to 10 N·m (89 lb in).

  3. Connect the accelerator pedal position sensor electrical connector.
  4. Confirm that the accelerator sensor connector locking clip is fully secured.
  5. Verify the operation of the accelerator pedal.