1. Disconnect the knock sensor (KS) electrical connector (1).
2. Remove the KS electrical connector clip from the oil level indicator tube bracket.
3. Remove the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement .



4. Remove the KS bolt.
5. Remove the KS.

Important: Rotate the pigtail 90 degrees from vertical before securing the fastener.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the KS.
2. Install the KS bolt.

Tighten
Tighten the bolt to 25 N·m (18 lb ft).




3. Connect the KS electrical connector (1).
4. Install the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement .
5. Install the KS electrical connector clip to the oil level indicator tube bracket.