Preliminary Procedures

1. Remove the control valve body cover. Refer to Control Valve Body Cover Replacement .
2. Perform the service fast learn adapt procedure. Refer to Service Fast Learn Adapts .

1

Input Speed Sensor (ISS) Wire Harness

Procedure

Attach the DT-47734 speed sensor harness tether to the ISS electrical connector locking tab before removal of old ISS to assist in installation of the new ISS.

Special Tools

DT-47734 Speed Sensor Harness Tether

2

Input Speed Sensor Bolt M6 x 25

Notice: Refer to Fastener Notice in the Preface section.

Procedure

Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the input speed sensor bolt.

Tighten
9 N·m (7 lb in)

3

Input Speed Sensor

Tip
After an internal transmission repair or internal part replacement the service fast learn adapt procedure should be performed.

4

Input Speed Sensor Seal