GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1838938  Size: SH
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
  2. Disconnect the chassis EVAP pipe (3) quick connect fitting from the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service.

  3. Object Number: 1839730  Size: SH
  4. Disconnect the EVAP emission canister tube quick connect fitting (2) from the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service.

  5. Object Number: 1839426  Size: SH
  6. Disconnect the engine wiring harness electrical connector (2) from the evaporative emission (EVAP) purge solenoid.

  7. Object Number: 1839422  Size: SH
  8. Remove the EVAP purge solenoid bracket bolt.
  9. Remove the EVAP purge solenoid.

Installation Procedure


    Object Number: 1839422  Size: SH
  1. Position the EVAP purge solenoid.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the EVAP purge solenoid bracket bolt.
  4. Tighten
    Tighten the bolt to 10 N·m (89 lb in).

  5. Connect the EVAP pipe quick connect fitting (2) to the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service.

  6. Object Number: 1839426  Size: SH
  7. Connect the engine wiring harness electrical connector (2) to the EVAP purge solenoid.

  8. Object Number: 1839730  Size: SH
  9. Connect the EVAP emission canister tube quick connect fitting (2) to the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service.

  10. Object Number: 1838938  Size: SH
  11. Connect the chassis EVAP pipe (3) quick connect fitting to the EVAP purge solenoid. Refer to Plastic Collar Quick Connect Fitting Service.
  12. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.