Air Cleaner Element Replacement NT7

1. Disconnect the mass air flow (MAF) sensor harness connector.
2. Remove the upper air cleaner cover screws.
3. Remove the upper air cleaner cover.
4. Remove the air cleaner filter from the lower air cleaner housing.
5. Inspect the air cleaner filter for dust, dirt and water contamination.
6. Replace as necessary. Refer to Maintenance Schedule.

1. Install the air cleaner filter into the lower air cleaner housing.
2. Install the upper air cleaner cover to the lower air cleaner housing.

Notice: Refer to Fastener Notice in the Preface section.

3. Secure the air cleaner housing cover.

Tighten
Tighten the air cleaner cover screws to 5 N·m (44 lb in).

4. Connect the MAF sensor harness connector.