Sunroof Control Module Programming and Setup W/RPO CF5

The sunroof motor/actuator uses sensor inputs to continuously monitor the location of the glass panel and to establish soft stop locations several millimeters ahead of the hard stops (physical limits) of the glass panel. The sunroof motor/actuator includes the sunroof motor, actuator, sensors and the control module. These components are not serviced individually.

If the sunroof motor/actuator is replaced, the initialization procedure must be performed in the following order:

1. Place the ignition switch to the ON position.
2. Press and hold the sunroof switch to the OPEN position until the glass panel stalls at the rear hard stop in the fully open position, and then moves back to the soft stop position.
3. Release the sunroof switch.
4. Within 6 seconds, press and hold the switch button again to the OPEN position. After 3 more seconds, the sunroof window will move toward the CLOSE position. Continue holding the switch until the sunroof window stops at the closed position.
5. Release the sunroof switch.
6. Verify sunroof operation. Refer to Sunroof Description and Operation .

The initialization procedure is not complete if one of the following actions occurs before the procedure is complete:

This component is not re-programmable.

If battery positive voltage or ground is removed and re-installed from the sunroof motor/actuator, the following procedure must be performed in the following order:

1. Place the ignition switch to the ON position.
2. Press and hold the sunroof switch to the OPEN position until the glass panel stops at the rear soft stop position.
3. Release the sunroof switch.
4. Press and hold the sunroof switch again to the OPEN position for 10 seconds or more. The sunroof will stall at the hard stop position, then move back to the soft stop position.
5. Release the sunroof switch.
6. Within 6 seconds, press and hold the sunroof switch again to the OPEN position. After 3 more seconds, the glass panel will move toward the close position. Continue pressing the switch until the glass stops at the closed position.
7. Release the sunroof switch.
8. Verify sunroof operation. Refer to Sunroof Description and Operation .

The re-initialization procedure is not complete if one of the following actions occur before the procedure is complete:

Sunroof Control Module Programming and Setup W/RPO C3Y

The sunroof motor/actuator uses sensor inputs to continuously monitor the location of the glass panels and to establish soft stop locations several millimeters ahead of the hard stops (physical limits) of the glass panels. The sunroof motor/actuator includes the sunroof motor, actuator, sensors and the control module. These components are not serviced individually.

If the sunroof motor/actuator is replaced, the initialization procedure must be performed in the following order:

1. Place the ignition switch to the ON position.
2. Press and hold the sunshade switch to the CLOSE position.
3. With the sunshade switch held to the CLOSE position, turn the rotary sunroof switch to the full OPEN position, and then to the full CLOSE position. Wait until both the sunshade and glass close and remain closed for approximately 2 seconds. Both the sunshade and the glass will stall at the full closed position.
4. Release the sunshade switch.
5. Within 6 seconds, press the sunshade switch to the CLOSE position 2 more times and then hold it in the CLOSE position. The glass and the sunshade will travel to the full open position and then stall for approximately 1 second before returning to the full closed position. Continue to hold the sunshade switch to the CLOSE position for approximately 2 seconds to complete the procedure.
6. Verify sunroof operation. Refer to Sunroof Description and Operation .

The initialization procedure is not complete if one of the following actions occurs before the procedure is complete:

This component is not re-programmable.

If the sunroof motor/actuator has been removed and re-installed, or if battery positive voltage or ground has been removed from the motor/actuator for any reason, follow the sunroof motor/actuator replacement initialization procedure.