Circuit Description
The power steering control module (PSCM) has a discrete battery positive voltage supply circuit. The PSCM monitors the voltage level on this circuit to ensure the power steering system has adequate voltage levels to perform the system functions.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC C0896 Device Voltage Range/Performance
This vehicle has DTCs which include DTC symptoms. For more information on DTC symptoms, refer to DTC Symptom Description .
DTC Symptom | DTC Symptom Descriptor |
|---|---|
00 | No Additional DTC Information |
Conditions for Running the DTC
The ignition is ON, with the engine ON.
Conditions for Setting the DTC
Power steering system battery voltage is 9-10 volts for at least one second.
Action Taken When the DTC Sets
| • | DTC C0896 00 is stored in memory. |
| • | Steering assist is slightly reduced. |
Conditions for Clearing the DTC
| • | A current DTC will clear when power steering system voltage is greater than 10 volts for more than one second. |
| • | A history DTC will clear after 100 consecutive ignition cycles with the power steering system voltage greater than 10 volts. |
Test Description
The number below refers to the step number on the diagnostic table.
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Power Steering Schematics Connector End Views Reference: Power Steering Connector End Views | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |
Does the scan tool indicate that the Battery Voltage parameter is greater than the specified value? | 10 V | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 | |
3 | Inspect for poor connections at the underhood fuse block stud ring terminal. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 4 |
4 | Inspect for poor connections at the ground terminal G103. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 5 |
5 | Inspect for poor connections at the 80-amp EPS fuse in the underhood fuse block. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 6 |
6 | Inspect for poor connections at the power steering control module (PSCM) harness connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 7 |
7 | Test the battery positive voltage circuit of the PSCM for a high resistance. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 8 |
8 | Test the ground circuit of the PSCM for a high resistance. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 9 |
9 | Replace the power steering motor and module assembly. Refer to Power Steering Assist Motor Replacement . Did you complete the replacement? | -- | Go to Step 10 | -- |
10 |
Does DTC C0896 reset? | -- | Go to Step 2 | System OK |
