GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2007 🢒 G5 🢒 General Information 🢒 General Information 🢒 Wheel Drive Shaft Heat Shield Replacement

Removal Procedure

    Object Number: 878832 Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the wheel drive shaft heat shield bolt at the transaxle mount bracket.
  3. Remove the drive shaft heat shield bolt at the engine block.
  4. Remove the wheel drive shaft heat shield.

Installation Procedure

    Object Number: 878832 Size: SH
  1. Install the wheel drive shaft heat shield into position on the vehicle.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the wheel drive shaft heat shield bolt to the engine block.

    3. Tighten
    Tighten the bolt to 30 N·m (22 lb ft).

  3. Install the wheel drive shaft heat shield bolt to the transaxle mount bracket.

    4. Tighten
    Tighten the bolt to 10 N·m (89 lb in).

  4. Lower the vehicle.