Step | Action | Values | Yes | No |
|---|---|---|---|---|
1 | Does the engine knock at idle when hot? | -- | Go to Step 2 | System OK |
2 | Inspect the drive belts. Are the belts loose or worn? | -- | Go to Step 3 | Go to Step 4 |
3 | Tension or replace the belts, as necessary. Did you complete the repair? | -- | Go to Step 1 | -- |
4 | Inspect the A/C compressor and the generator. Is either the compressor or the generator faulty? | -- | Go to Step 5 | Go to Step 6 |
5 | Replace the faulty A/C compressor or the generator. Did you complete the replacement? | -- | Go to Step 1 | -- |
6 | Inspect the valve train. Are valve train components faulty? | -- | Go to Step 7 | Go to Step 8 |
7 | Replace the faulty valve train components. Did you complete the replacement? | -- | Go to Step 1 | -- |
8 | Inspect the engine oil. Is the proper viscosity oil used in the crankcase? | -- | Go to Step 10 | Go to Step 9 |
9 | Install oil of the proper viscosity for the expected seasonal temperatures. Did you complete the repair? | -- | Go to Step 1 | -- |
10 | Inspect the piston pin clearance. Is the clearance more than the specified value? | 0.02 mm (0.0008 in) | Go to Step 11 | Go to Step 12 |
11 | Replace the piston and the pin. Did you complete the replacement? | -- | Go to Step 1 | -- |
12 | Inspect the connecting rod alignment. Is the alignment faulty? | -- | Go to Step 13 | Go to Step 14 |
13 | Inspect and replace rods, as necessary. Did you find and correct the condition? | -- | Go to Step 1 | -- |
14 | Inspect the piston-to-bore clearance. Is the clearance within the specified value? | 0.03 mm (0.0012 in) | Go to Step 16 | Go to Step 15 |
15 | Hone the bore and fit a new piston. Did you complete the repair? | -- | Go to Step 1 | -- |
16 | Inspect the crankshaft balancer. Is the balancer loose? | -- | Go to Step 17 | Go to Step 18 |
17 | Torque or replace worn parts. Did you complete the repair? | -- | Go to Step 1 | -- |
18 | Inspect the piston pin offset. Is the offset toward the thrust side at the specified range? | 0.4-0.6 mm (0.02-0.003 in) | Go to Step 19 | System OK |
19 | Install the correct piston. Did you complete the repair? | -- | Go to Step 1 | -- |
