Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
|
Important: The factory sets the theft deterrent shock sensor to a middle range of sensitivity. Depending on your area or usage, the factory setting may be too sensitive or not sensitive enough. Make sure that the tamper label on the knob that adjusts the shock sensor is not broken or altered. If the label is broken or altered, the shock sensor may be misadjusted to a setting that is less sensitive. | ||||
1 | Did you perform the Diagnostic System Check? | -- | ||
2 | Does the shock sensor operate normally? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | |
3 |
Does the BCM chime sound when you tap the shock sensor? | -- | ||
4 | The shock sensor may be misadjusted. In order to adjust the shock sensor, refer to Shock Sensor Replacement . Is the adjustment complete? | -- | -- | |
5 |
Does the test lamp illuminate? | -- | ||
6 | Connect a test lamp between the shock sensor terminal A and ground. Refer to Circuit Testing in Wiring Systems. Does the test lamp illuminate? | -- | ||
7 | Repair the open in circuit 640 between S211 and the shock sensor terminal A. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | -- | |
8 | Repair the open in circuit 650 between S217 and the shock sensor terminal C. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | -- | |
9 | Connect a test lamp between the shock sensor harness connector terminal D and ground. Refer to Circuit Testing in Wiring Systems. Does the BCM chime sound when the test lamp is connected (the horn may also sound)? | -- | ||
10 | Connect a test lamp between the shock sensor harness connector terminal B and ground. Refer to Circuit Testing in Wiring Systems. Does the BCM chime sound when the test lamp is connected (the horn may also sound)? | -- | ||
11 | Test for and repair a poor connection at the shock sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and repair a poor connection? | -- | ||
12 | Replace the shock sensor. Refer to Shock Sensor Replacement . Did you complete the replacement? | -- | -- | |
13 | Connect a test lamp between the BCM connector C3 terminal D14 and ground. Refer to Circuit Testing in Wiring Systems. Does the BCM chime sound when the test lamp is connected (the horn may also sound)? | -- | ||
14 | Repair the open in circuit 1828 between the BCM and the shock sensor. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | -- | |
15 | Test for and repair a poor connection at the BCM connector C3 terminal D14. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and repair a poor connection? | -- | ||
16 | Connect a test lamp between the BCM connector C3 terminal D2 and ground. Refer to Circuit Testing in Wiring Systems. Does the BCM chime sound when the test lamp is connected (the horn may also sound)? | -- | ||
17 | Repair the open in circuit 263 between the BCM and the shock sensor. Refer to Wiring Repairs in Wiring Systems. Did you complete the replacement? | -- | -- | |
18 | Test for and repair a poor connection at the BCM connector C3 terminal D2. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and repair a poor connection? | -- | ||
19 |
Important: Perform the set up procedure for the body control module. Replace the BCM. Refer to Body Control Module Replacement in Body Control System. Did you complete the replacement? | -- | -- | |
20 | Operate the system in order to verify the repair. | -- | System OK | |
