1. Press the UNLOCK button once in order to perform the following operations:

•	Unlock the drivers side door

•	Activate the illuminated entry

•	Disarm the universal theft-deterrent system

2. Press the UNLOCK button a second time, within 5 seconds, in order to unlock the passenger door.

1. On vehicles with an automatic transmission, perform one of the following operations:

•	Place the shift lever in the PARK position.

•	Turn the ignition switch to the OFF position.

2. On vehicles with a manual transmission, perform both of the following operations:

•	Turn the ignition switch to the ON position.

•	Set the park brake.

3. Press the button marked with the vehicle symbol in order to perform the following operations:

•	Release the rear compartment lift window panel

•	Activate the illuminated entry

Press the LOCK button in order to perform the following operations:

Press the button that is marked with the horn symbol in order to activate the emergency panic mode. This mode will activate the horn and the parking lights intermittently until the panic mode button is pressed again.

The remote control door lock transmitter transmits a radio signal to the body control module (BCM). The BCM controls the functions of the transmitter. The transmitter range is approximately 9 m (30 feet).

The transmitter data is encrypted, and changes with each use. If the transmitter buttons are pressed too many times out of range from the vehicle the transmitter and the BCM will get out of synchronization. This will result in the transmitter appearing not to work at all. This situations will occur after the transmitter button is depressed more that 256 times when it is out of range from the vehicle. This may also be necessary if the transmitter battery has been replaced and the buttons were pushed a few times out of range. If the transmitter and the BCM get out of synchronization, re-synchronize the transmitter and the BCM. Refer to Transmitter Programming/Synchronization

The Body Control Module (BCM) is battery fed. The BCM is always monitoring the transmitter signal. When the BCM receives the correct transmitter signal the following actions occur:

1. A transistor driver energizes the correct lock control relay coil.
2. The transistor driver will arm the universal theft-deterrent, if equipped.
3. The doors lock.

The BCM also regulates which lock control relays will be energized in order to perform the following operations:

For replacement of the BCM, refer to Body Control Module Replacement in Body Control System.