Remote CD Changer Replacement Coupe

1. Open the rear compartment lift window panel.
2. Remove the compact disc (CD) magazine from the CD player.



3. Remove the CD changer mounting nut (1).
4. Disconnect the CD changer electrical connector (3).
5. Remove the CD changer (2).



6. Remove the bolts and the brackets from the CD changer, as needed.
7. If you will transport or ship the CD changer, reinstall the shipper pin. Insert the pin into the top of the changer. Use tape in order to fix the pin in place.
8. If you install a new CD changer, remove the shipper pin. Cover the hole with the supplied adhesive material.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the brackets and the bolts to the CD changer, as needed.

Tighten
Tighten the bolts to 1.9 N·m (17 lb in).




2. Install the CD changer (2).
3. Connect the CD changer electrical connector (3).
4. Position the outboard stud through the bracket hole.
5. Position the outboard hole over the stud.
6. Install the CD changer mounting nut (1).

Tighten
Tighten the nut (1) to 2.5 N·m (22 lb in).




7. Install the CD magazine to the CD changer.
8. Close the rear compartment lift window panel.

Remote CD Changer Replacement Convertible

1. Open the trunk.
2. Remove the compact disc (CD) magazine from the CD player.



3. Remove the CD changer mounting nut.
4. Disconnect the CD changer electrical connector.
5. Remove the CD changer.



6. Remove the bolts and brackets from the CD changer, as needed.
7. If you will transport or ship the CD changer , reinstall the shipper pin. Insert the pin into the top of the changer. Use tape in order to fix the pin in place.
8. If you install a new CD changer, remove the shipper pin. Cover the hole with the supplied adhesive material.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the brackets and the bolts to the CD changer, as needed.

Tighten
Tighten the bolts to 1.9 N·m (17 lb in).




2. Install the CD changer.
3. Connect the CD changer electrical connector.
4. Position the inboard stud through the bracket hole.
5. Position the inboard hole over the stud.
6. Install the CD changer mounting nut.

Tighten
Tighten the nut to 2.5 N·m (22 lb in).




7. Install the CD magazine to the CD changer.
8. Close the trunk.