Did you perform the Diagnostic System Check?

--

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

1. Turn the ignition to the OFF position.
2. Ensure that the turn signal switch is OFF.

Do the turn signal lamps remain off?

--

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Leave the ignition switch at the OFF position.
2. Place the turn signal and hazard switches to the OFF position.
3. Disconnect the turn/hazard switch assembly connector C216.

Are the turn signal lamps still on?

--

Go to Step 4

Go to Step 5

Repair a short to battery voltage in the supply voltage circuit of the turn signal lamps. Refer to Wiring Repairs in Wiring Systems.

Did you complete the repair?

--

Go to Step 6

--

Replace the turn/hazard switch assembly. Refer to Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle and Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle in Steering Wheel and Column - Tilt.

Did you complete the replacement?

--

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 3