Tools Required

1. Remove the exhaust gas recirculation (EGR) valve pipe bolts (2, 3, and 4).
2. Remove the EGR valve pipe (1) and solenoid.



3. Remove two strut mounting nuts from the left and right strut towers.
4. Screw the engine support fixture adapters J 28467-90A onto the strut tower studs.
5. Set the engine support adapters J 41044-1 and J 41044-2 over the fixture adapters J 28467-90A on each strut tower.
6. Secure with the wings nuts provided.
7. Place the cross bar J 28467-3 into the engine support adapters J 41044-1 and J 41044-2.
8. Secure with the quick release pins.
9. Install the fixture support leg J 28467-2A through the cross bracket J 28467-1A on the top of the cross bar J 28467-3.
10. Place the rubber padded foot of the front support J 28467-4A on the radiator support.
11. Install the tube of the front support J 28467-4A through the large hole in the support leg J 28467-2A until level.
12. Install the quick release pin.
13. Install the support leg J 36462-A through the cross bracket J 28467-1A on the top of the cross bar J 28467-3.
14. Bolt the lifting brackets to the cylinder heads.
15. Thread lift hooks J 28467-50 and J 28467-8 or (8A) into the support hook brackets J 28467-6A.
16. Place the support hook brackets J 28467-6A over the cross bar J 28467-3 and connect the hooks to the lifting brackets.
17. Tighten the large wing nuts J 28467-34.