GM Service Manual Online
For 1990-2009 cars only

Noise Diagnosis - Rear of Vehicle FoldingTop Pump Rattle

Folding Top Pump Rattle


Object Number: 397250  Size: SH

Symptom:

Rattle coming from the rear of the vehicle.

Possible Cause:

    • Folding top pump mounting nuts (1) loose or missing.
    • Mounting stud(s) missing or broken.

Diagnosis:

Visually inspect for mounting studs and nuts (1).

Corrective Action:

    • Replace missing or broken studs with bolts.
    • Tighten the mounting nuts to specification.

Tighten
Tighten the pump mounting nuts (1) to 6 N·m (53 lb in).

Noise Diagnosis - Rear of Vehicle Passenger Side B-Pillar Creak

Passenger Side B-Pillar Creak


Object Number: 397260  Size: MH

Symptom

Creak coming from the upper B-pillar/roof area on the passenger side. Usually only happens over 16°C (60°F) ambient temperature.

Possible Cause

Sheet metal interference in the middle to the upper area of the B-pillar.

Diagnosis

Remove B-pillar quarter inner trim finishing panel. Test drive the vehicle, listen for noise over rough roads.

Corrective Action

Strike the B-pillar sheet metal, inside the vehicle, with a ball peened hammer to put a slight indentation in the inside body panel.

Noise Diagnosis - Rear of Vehicle Radio Rear Speaker Rattle

Radio Rear Speaker Rattle


Object Number: 362247  Size: SH

Symptom

Rattle from the rear speaker located on the rear quarter trim panel.

Possible Cause

The rivets do not hold well due to improper installation.

Diagnosis

    • Remove the rear quarter trim.
    • Check speaker attachment to the trim for looseness.

Corrective Action

Install new rivets or isolation material as necessary.

Noise Diagnosis - Rear of Vehicle Rear Compartment Closeout Panel Rattl

Rear Compartment Closeout Panel Rattle


Object Number: 397264  Size: SH

Symptom

Rattle from the rear of the vehicle.

Possible Cause

Rear compartment closeout panel (2) rattles against the side trim.

Diagnosis

Remove the closeout panel (2) and test drive the vehicle.

Corrective Action

Apply a 2 in x 5

Noise Diagnosis - Rear of Vehicle Hatch Rattle

Hatch Rattle


Object Number: 397266  Size: SH

Symptom

A rattle coming from the rear hatch area.

Possible Cause

    • The hatch latch is not in the correct position, both cross-car and up/down.
    • Overslam bumpers are not properly set.

Diagnosis

Test drive the vehicle and, with the aid of a helper, push up on the rear compartment lift window panel to stop the noise.

Corrective Action

    • Loosen the latch.
    • Center with the striker and retighten. Be sure to provide equal clearance to the latch sides.
    • Lower the lift window pane and run bumpers out to a point that a single piece of paper can barely be pulled out when the rear panel is fully closed.

Noise Diagnosis - Rear of Vehicle Rear Compartment Lift Window Panel Co

Rear Compartment Lift Window Panel Cover Rattle


Object Number: 397267  Size: SH

Symptom

Rattle from the rear compartment trim area.

Possible Cause

Trim is loose due to misinstalled or missing fasteners.

Diagnosis

Carefully pull the rear compartment trim down to view behind, look for misinstalled or missing fasteners.

Corrective Action

Install new fastener.

Noise Diagnosis - Rear of Vehicle Rear Quarter Panel Styrofoam Itch

Rear Quarter Panel Styrofoam Itch


Object Number: 397275  Size: SH

Symptom

High pitched itch coming from the rear (right, left or both) of the vehicle over moderate to rough roads. Sounds similar to sheet metal joint creaks.

Possible Cause

The stryofoam inserts located behind the quarter trim panel are contacting and rubbing against the quarter inner sheet metal surfaces.

Diagnosis

Look for witness marks on the styrofoam insert of the quarter panel inner sheet metal surface.

Corrective Action

Apply 3 pieces of 30 x 80 mm GM 6068M closed cell foam (P/N 22638774) or similar isolation material at specified location. Wrap foam around edges approximately 1/4 inch.