Circuit Description
Battery positive voltage is supplied at all times to the seat adjuster switch and the memory seat module (MSM) through the same circuit. The MSM uses this battery voltage input to determine if battery positive voltage is applied to the seat adjuster switch.
Conditions for Running the DTC
The MSM must be powered and cannot have B1327-Battery Voltage Low as an active DTC for this DTC to set.
Conditions for Setting the DTC
This DTC will set only when the MSM detects less than 3 volts from the circuit.
Action Taken When the DTC Sets
| • | The MSM ignores all memory recall commands. |
| • | All manual seat functions will operate. |
Conditions for Clearing the DTC
The DTC will clear when the MSM detects that the voltage from the circuit is greater than 3 volts.
Test Description
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Driver Seat Schematics Connector End View Reference: Power Seat Connector End Views | |||
1 | Did you perform the Diagnostic System Check-Power Seat Systems? | Go to Step 2 | |
2 | Activate any one of the power seat adjuster switches. Does the seat move in the commanded direction? | Go to Step 3 | Go to Step 4 |
3 | Probe the battery positive voltage circuit of the memory seat module connector C2 Pin-D11 with a test lamp that is connected to ground. Does the test lamp illuminate? | Go to Step 5 | Go to Step 6 |
4 | Test all of the power seat and lumbar switch signal circuits between the seat adjuster switch and the memory seat module for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 9 | Go to Step 7 |
5 | Inspect for poor connections at the harness connector of the memory seat module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 9 | Go to Step 8 |
6 | Repair the open in the battery positive voltage circuit of the memory seat module. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 9 | -- |
7 | Repair the short to ground or open in the battery positive voltage circuit of the seat adjuster switch/memory seat module. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you complete the repair? | Go to Step 9 | -- |
8 | Replace the memory seat module. Refer to Memory Seat Control Module Replacement . Did you complete the replacement? | Go to Step 9 | -- |
Does the DTC reset? | Go to Step 2 | System OK | |
