GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 39194 Oxygen Sensor Wrench

Removal Procedure

  1. Turn OFF the ignition.
  2. Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

  3. Raise and support the vehicle.

  4. Object Number: 402074  Size: SH
  5. Remove the splash shield (3).
  6. Disconnect the electrical connector retaining tab (1) from the HO2S electrical connector (2).
  7. Disconnect the oxygen sensor connector (4) from the HO2S electrical connector (2).
  8. Important: The heated oxygen sensor may be difficult to remove when engine temperature is below 48°C (120°F). Excessive force may damage threads in exhaust manifold or exhaust pipe.

  9. Use the J 39194 in order to remove the oxygen sensor (4) from the exhaust pipe .

Installation Procedure

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 402074  Size: SH
  1. Install the oxygen sensor (4) in the exhaust pipe.
  2. Tighten
    Tighten the sensor to 41 N·m (30 lb ft).

  3. Connect the electrical connector (2) to the HO2S (4).
  4. Connect the HO2S electrical connector retaining tab (1).
  5. Install the front splash shield (3).
  6. Lower the vehicle.