GM Service Manual Online
For 1990-2009 cars only

Object Number: 428864  Size: MF
Driver Door Module (DDM) Inputs/Outputs
Cell 114: LH Courtesy Lamps
Handling ESD Sensitive Parts Notice

Circuit Description

The switch that failed and generated this diagnostic trouble code (DTC) is part of the driver door switch assembly. This assembly contains a microprocessor which takes the signal generated by this switch and assigns a digital message to the switch signal. The driver door switch assembly then sends this message over a simple bus interface (SBI) link to the driver door module (DDM). The DDM then either moves the left mirror or sends commands over the SBI to the right front door module to move the right mirror.

Conditions for Running the DTC

The DDM must be powered for this DTC to set.

Conditions for Setting the DTC

If the driver door module receives the message that the switch is closed for more than 30 continuous seconds, the driver door module sets this DTC.

Action Taken When the DTC Sets

The DDM ignores the continuous message from the driver door switch assembly for this switch, rules it invalid, and will not respond to it. The DDM will not respond to the invalid mirror switch message as a command for either door mirror. The DDM will respond to all other valid switch messages.

Conditions for Clearing the DTC

The DDM clears this DTC when the switch message status changes.

Step

Action

Yes

No

1

Did you perform A Diagnostic System Check - Door Systems?

Go to Step 2

Go to Diagnostic System Check - Door Systems

2

  1. Install a scan tool.
  2. Turn ON the ignition leaving the engine OFF.
  3. Observe the Driver Mirror Switches parameter in the Driver Door Module data list using the scan tool.

Does the scan tool display Idle?

Go to Step 3

Go to Step 4

3

  1. Activate the mirror switch in all directions.
  2. Observe the Driver Mirror Switches parameter using the scan tool.

Does the Driver Mirror Switches parameter change state?

Go to Step 9

Go to Step 4

4

  1. Turn OFF the ignition.
  2. Disconnect the driver door switch assembly (DDSA).
  3. Turn ON the ignition leaving the engine OFF.
  4. Observe the Driver Mirror Switches parameter using the scan tool.

Does the scan tool indicate the Idle state?

Go to Step 6

Go to Step 5

5

Inspect for poor connections/terminal tension at the driver door module harness connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 7

6

Inspect for poor connections/terminal tension at the DDSA harness connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 8

7

Replace the driver door module. Refer to Door Control Module Replacement .

Did you complete the replacement?

Go to Step 9

--

8

Replace the DDSA. Refer to Front Door Switch Replacement .

Did you complete the replacement?

Go to Step 9

--

9

  1. Clear the DTCs using the scan tool.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

Go to Step 2

System OK