Circuit Description
The passenger mirror vertical position sensor is a potentiometer. The driver door module (DDM) determines the vertical position of the mirror based on the voltage from the sensor. The sensor is powered by the right front door module (RFDM). The RFDM converts the sensor signal voltage to a simple bus digital signal and communicates it to the DDM.
Conditions for Running the DTC
The DDM and the RFDM must be powered up.
Conditions for Setting the DTC
The signal voltage is more than 4.75 V for more than 2 seconds in the requested position.
Action Taken When the DTC Sets
Memory movements on this axis are disabled. Manual movements are not disabled.
Conditions for Clearing the DTC
When the DDM no longer detects a failure.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform A Diagnostic System Check - Door Systems ? | -- | ||
2 |
Does the scan tool indicate the voltage varies and is within the specified range? | 0.25-4.75 V | ||
3 |
Does the voltage measure near the specified value? | 4.75 - 5.50 V | ||
4 |
Does the scan tool indicate the voltage is near the specified value? | 0-0.25 V | ||
5 | Inspect for poor connections/terminal tension at the right front door module (RFDM) harness connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | ||
6 | Replace the RH Mirror. Refer to Power Mirror Replacement Did you complete the replacement? | -- | -- | |
7 | Replace the RFDM . Refer to Door Control Module Replacement . Did you complete the replacement? | -- | -- | |
8 |
Does the DTC reset? | -- | System OK |
