For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B3106 00: Keyless Entry Data Link Parity ErrorCircuit/System Description
The remote function receiver module receives a signal from the keyless entry transmitters when a button is pressed; it then sends the request to the BCM.
Conditions for Setting the DTC
The BCM detects an invalid message from the remote function receiver module; a message with a parity error. This indicates an internal fault within the remote function receiver module.
Action Taken When the DTC Sets
No action is taken.
Conditions for Clearing the DTC
| • | A current DTC will clear when the fault is no longer present and the ignition switch is cycled. |
| • | The history DTC will clear after 100 consecutive ignition cycles without a fault present. |
| • | A scan tool may be used to clear history and current DTCs. |
Reference Information
Schematic Reference
Component Connector End Views
Description and Operation
Keyless Entry System Description and Operation
Electrical Information Reference
Circuit/System Testing
- With a valid transmitter, press a button on the transmitter.
- Verify that DTC B3106 is set.
- Replace the K84 remote function receiver module.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for remote function receiver module replacement, setup, and programming
