Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1015 00: Vehicle Identification Number Information MalfunctionCircuit/System Description
When the ignition is turned ON, the object alarm module receives the vehicle identification number (VIN) from the body control module (BCM). The object alarm module will compare the VIN received to the VIN stored in memory.
Conditions for Running the DTC
Ignition voltage is between 9-16 V.
Conditions for Setting the DTC
The VIN stored in the object alarm module does not match the received VIN.
Action Taken When the DTC Sets
| • | The parking assist is disabled. |
| • | The parking assist indicator in the instrument panel cluster will be activated. |
Conditions for Clearing the DTC
The VIN stored in the object alarm module matches the VIN stored in the BCM.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Object Detection Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Ignition ON, program the K41 Object Alarm Module and verify the DTC does not reset.
| ⇒ | If the DTC is reset, replace the K41 Object Alarm Module |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for Object Alarm Module replacement, setup and programming
