Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0775 00: Tire Pressure Monitoring System Sensors MalfunctionCircuit/System Description
If the tire pressure sensor learn/autolearn procedure has not been performed, the tire pressure monitor system indicator icon on the instrument cluster will flash for 1 min. and then remain illuminated after the ignition switch is cycled ON and the instrument cluster bulb check is complete. If equipped, the driver information center will also display a service tire monitor type message. Under these circumstances, DTC C0775 will be set and the tire pressure sensor learn procedure will need to be performed for the system to function correctly. Auto learn functionality: In addition to the sensors signal, the tire pressure monitor system also receives the left/right information sent by the sensors. This information is determined by the rotating direction of the tire. The tire pressure monitor system decides if the tire which is sending information is located at the front or rear axle. It can determine that information by the sensors signal strength.This process takes about 3-9 min of driving.
Conditions for Running the DTC
Ignition ON.
Conditions for Setting the DTC
The body control module (BCM) has not undergone the tire pressure sensors learn procedure or the auto learn function is failled.
Action Taken When the DTC Sets
| • | The tire pressure monitor system indicator icon on the instrument cluster will flash for 1 min. and then remain illuminated after the ignition switch is cycled ON and the instrument cluster bulb check is complete. |
| • | If equipped, the driver information center displays a service tire monitor type warning message. |
Conditions for Clearing the DTC
A current DTC will clear when the BCM has undergone the tire pressure sensor learn procedure or the auto learn procedure was successfull and 1 ignition cycle has occurred.
Reference Information
Schematic Reference
Tire Pressure Monitoring System Schematics
Connector End View Reference
Description and Operation
Tire Pressure Monitor Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for diagnostic tester information
Circuit/System Verification
Verify that the DTC C0569 or DTC C0775 is not set.
| ⇒ | If the DTC is set, perform the Body Control Module (BCM) Tire Pressure Sensors Learn with the scan tool and cycle the ignition. If the DTC resets, replace the K9 Body Control Module (BCM). |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for BCM replacement, setup and programming
