GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Opel 🢒 2007 🢒 Antara 🢒 DTC 🢒 DTC P0617

Circuit Description

The engine control module (ECM) supplies a ground path for the starter relay when start enable has been requested. The ECM monitors this circuit for conditions that are incorrect for the commanded state. If the ECM detects an improper circuit condition, starter relay DTC P0616 will set.

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC P0617 Starter Relay Control Circuit High Voltage

Conditions for Running the DTC
    • System voltage is between 8-16 volts.
    • The engine is running.

Conditions for Setting the DTC
    • The ECM detects an improper voltage level on the control circuit that controls the starter relay.
    • The condition exists for at least 2 seconds.

Action Taken When the DTC Sets
    • The ECM will not illuminate the malfunction indicator lamp (MIL).
    • The ECM will store the conditions present when the DTC set as Failure Records data only.

Conditions for Clearing the MIL/DTC
    • The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
    • The DTC can be cleared by using the scan tool Clear DTC Information function.

Step

Action

Yes

No

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2
  1. Install a scan tool.
  2. Operate the vehicle within the Conditions for Running the DTC.
  3. Using the scan tool, observe the specific DTC information for DTC P0617 until the test runs.

Does the scan tool indicate that DTC P0617 has passed this ignition cycle?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

3

Test the control circuit of the starter relay for a short to battery. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 6

Go to Step 4

4

Inspect for poor connections at the engine control module (ECM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 6

Go to Step 5

5

Replace the ECM. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 6

--

6
  1. Review and record the scan tool Failure Records data.
  2. Use the scan tool in order to clear the DTC.
  3. Operate the vehicle within the Conditions for Running the DTC.
  4. Using the scan tool, observe the specific DTC information for DTC P0617 until the test runs.

Does the scan tool indicate that DTC P0617 failed this ignition?

Go to Step 2

System OK