POWER ANTENNA RELAY REPLACE P/N'S AND INSTALLATION

Models/Years 1979-84 Toronado; 1977-84 Cutlass Supreme, 88 & 98; 1981-82 Omega

Condition

When it becomes necessary to replace power antenna relays with part numbers 22510577, 556511 or 550893, a power antenna relay kit, part no. 22524833 should be used. This kit contains a mini relay, an adapter harness, and one four-way connector body. The relay kit replaces the original metal covered relays used on the following vehicles:

1979-84 Toronado 1977-84 Cutlass, 88 and 98 1981-82 Omega

Correction

Install the relay kit as follows:

1. Remove the failed relay.

2. Remove the staggered 3-way connector body from the power antenna wiring by releasing the secondary terminal locks and remove three (3) terminals and wires from the connector.

3. Install the above terminals into the four-way connector body, part no. 8917542 (furnished with the jumper harness) as follows:

Cavity A - Dk. Green Cavity B - Gray Cavity C - White Cavity D - Blank

Close the secondary lock latch and inspect for proper terminal engagement.

4. Plug one end of the jumper harness into the new relay, part no. 10030273 (2 connectors). Plug the other end onto the IP harness and the converted power antenna lead. Refer to the appropriate illustration.

5. Tape relay to IP harness in a horizontal or terminal down position so that it is rattle free.

6. Check power antenna operation.

Parts Information

The following part numbers are included in the power antenna relay kit, part number 2254833:

1 Mini Relay P/N 10030273 1 Adapter Harness P?N 12038466 1 Connector Body P/N 8917542

Note: Future relay replacement, after kit installation, will only require replacement of the relay, Part No. 10030273, or equivalent.

Warranty Information

Power antenna relay kits installed under warranty must be submitted using the following information.

Trouble Operation Labor Failed P/N Code Number Hours ---------- ---- ------ -----

22524833 92 R0620 0.3

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.