Schematic Reference: Audible Warnings Schematics

Did you review the operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Instrument Panel, Gages and Console

Are the Rear Parking Assist (RPA) indicators on?

Go to Rear Parking Assist Malfunction in Rear Parking Assist

Go to Step 3

Are any other indicators illuminated?

Go to Symptoms - Instrument Panel, Gages and Console

Go to Step 4

Test the control circuit of the IP BCM chime request for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 10

1. Turn OFF the ignition.
2. Make sure the headlamp and IP lamp dimmer switch is in the off position.
3. Disconnect the BCM connector C2.
4. Connect a test lamp between the headlamp and IP lamp dimmer switch circuit at the BCM and ground. Refer to Circuit Testing in Wiring Systems.

Does the test lamp illuminate?

Go to Step 6

Go to Step 8

Important: Refer to SIR Caution before working in the steering column.

Connect a test lamp between the control circuit of the ignition key alarm switch at the BCM and B+. Refer to Circuit Testing in Wiring Systems.

Does the test lamp illuminate?

Go to Step 7

Go to Step 14

1. Take the ignition key out of the ignition switch.
2. Connect a test lamp between the control circuit of the ignition key alarm switch and B+. Refer to Circuit Testing in Wiring Systems.

Does the test lamp illuminate?

Go to Step 9

Go to Step 14

Test the control circuit of the headlamp and IP lamp dimmer switch for an open . Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 13

1. Disconnect C201.
2. Leave the test lamp at the same location.

Does the test lamp illuminate?

Go to Step 12

Go to Step 15

Inspect for poor connections at the harness connector of the headlamp and IP lamp dimmer switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 11

Inspect for poor connections at the harness connector of the BCM connector C2. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 5

Repair a short to ground in the control circuit of the ignition key alarm switch. Refer to Wiring Repairs in Wiring Systems.

Did you complete the repair?

Go to Step 16

--

Replace the headlamp and IP lamp dimmer switch. Refer to Headlamp Switch Replacement in Lighting Systems.

Did you complete the replacement?

Go to Step 16

--

Replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 16

--

Replace the ignition key alarm switch. Refer to Ignition and Key Alarm Switch Assembly - Disassemble - Off Vehicle and Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle in Steering Wheel and Column - Tilt.

Did you complete the replacement?

Go to Step 16

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2