Schematic Reference: Video System Schematics

DEFINITION: The overhead and liftgate speakers do not mute when the radio is turned on, causing the overhead and liftgate speakers to play video audio while the radio is on.

Did you perform Diagnostic System Check - Entertainment System ?

--

Go to Step 2

Go to Diagnostic System Check - Entertainment System

1. Turn ON the ignition.
2. Turn on the wireless headphones.
3. Test the operation of the radio and rear seat audio (RSA) module with the rear video system off.
4. Turn off the radio and the RSA module.
5. Turn on power to the video cassette player (VCP) and the video display.
6. Insert a pre-recorded VHS tape in the VCP and press the PLAY button on the VCP. The video display plays video from the VCP. Video audio plays through the overhead speakers, liftgate speakers and the wireless headphones (both channels).
7. While the VCP is playing, turn the radio ON. The overhead speakers and liftgate speakers mute. The front speakers play radio audio. Video audio plays through the wireless headphones (both channels).

Does the system operate normally?

--

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Test the antenna relay coil supply voltage circuit for an open or a short to ground at the following locations:

Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 12

Go to Step 4

1. Turn OFF the ignition.
2. Disconnect the video display connector C1.
3. Turn ON the ignition.
4. Turn ON the radio.
5. Measure the voltage of the antenna relay coil supply voltage circuit at the video display connector C1.

Is the voltage within the specified range?

8 to 13.5 Volts

Go to Step 6

Go to Step 5

1. Turn OFF the ignition.
2. Disconnect the auxiliary module connector C2.
3. Turn ON the ignition.
4. Turn ON the radio.
5. Measure the voltage of the antenna relay coil supply voltage circuit at the auxiliary module connector C2.

Is the voltage within the specified range?

8 to 13.5 Volts

Go to Step 7

Go to Step 8

Inspect for poor connections at the harness connector C1 of the video display. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 12

Go to Step 9

Inspect for poor connections at the harness connectors C1 and C2 of the auxiliary module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 12

Go to Step 10

Inspect for poor connections at the harness connector of the radio. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

--

Go to Step 12

Go to Step 11

Replace the video display. Refer to Video Display Replacement .

Did you complete the replacement?

--

Go to Step 12

--

Replace the auxiliary module. Refer to Audio/Video Interface Module Replacement .

Did you complete the replacement?

--

Go to Step 12

--

1. Replace the radio. Refer to Radio Replacement .
2. Perform the radio setup. Refer to Radio Setup .

Did you complete the replacement?

--

Go to Step 12

--

Operate the system in order to verify the repair.

Did you correct the condition?

--

System OK

Go to Step 3