J 37043 Park Brake Cable Release Tool

1. Remove the left-side instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
2. Remove the left-side carpet retainer. Refer to Door Sill Plate Replacement in Interior Trim.
3. Fold back the carpet for access.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



5. Loosen the park brake cable equalizer nut in order to remove the park brake left side cable from the park brake equalizer.



6. Remove the park brake cable end from the park brake cable connector.
7. Remove the park brake cable from the park brake cable equalizer.



8. Remove the park brake cable from the park brake cable guides.
9. Remove the park brake cable nuts from the underbody studs.
10. Remove the park brake cable clips from the park brake cable.
11. Lower the vehicle.



12. Remove the park brake cable end from the park brake lever clevis.



13. Use the J 37043 in order to remove the cable from the lever.
14. Remove the front park brake cable from the vehicle.

1. Install the front park brake cable to the vehicle.



2. Install the park brake cable to the park brake lever.



3. Install the park brake cable end to the park brake lever clevis.
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



5. Install the park brake cable clips to the park brake cable shielded areas.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the park brake cable nuts to the underbody studs.

Tighten
Tighten the nuts to 3 N·m (27 lb in).

7. Install the park brake cable to the park brake cable guides.
8. Install the park brake cable to the park brake equalizer.



9. Install the park brake cable end to the park brake cable connector.



10. Install the park brake left side cable to the park brake equalizer.
11. Adjust the park brake cable. Refer to Park Brake Adjustment .
12. Lower the vehicle.
13. Fold the carpet back in place.
14. Install the left-side carpet retainer. Refer to Door Sill Plate Replacement in Interior Trim.
15. Install the left-side instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.