For 1990-2009 cars only
Removal Procedure
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
- Blow dirt out of the fitting using compressed air.
- Squeeze the plastic tabs on the male end connector.
- Pull the connection apart.
- Wipe off the male pipe end using a clean shop towel.
- Inspect both ends of the fitting for dirt and burrs.
- Clean or replace the components as required.
Caution: Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.
Notice: If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.
Installation Procedure
- Apply a few drops of clean engine oil to the male pipe end.
- Push both sides of the quick-connect fitting together in order to cause the retaining tabs to snap into place.
- Pull on both sides of the quick connect fitting in order to ensure the connection is secure.
Caution: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
