SMU - SECTION 10 - REVISED PROCEDURE FOR OUTSIDE MIRROR. Oldsmobile Ninety Eight 1994

REVISED: 10/19/94

THIS BULLETIN IS BEING REVISED TO INCLUDE THE 1992-93 MODEL YEARS FOR THE CADILLAC ELDORADO AND SEVILLE. ARTWORK REMAINS THE SAME. PLEASE DISCARD BULLETIN 431504 (GROUP REFERENCE 10 - BODY). ----------------------------------------------------------------------

SUBJECT: SERVICE MANUAL UPDATE - SECTION 10 - REVISED PROCEDURE FOR OUTSIDE ELECTROCHROMIC MIRROR FACE INSTALLATION

MODELS: 1992-94 BUICK PARK AVENUE 1995 BUICK RIVIERA 1992-93 CADILLAC DEVILLE AND FLEETWOOD 1992-94 CADILLAC ELDORADO AND SEVILLE 1994 CADILLAC CONCOURS AND DEVILLE 1992-94 OLDSMOBILE NINETY EIGHT 1995 OLDSMOBILE AURORA

THIS BULLETIN REVISES THE INSTALLATION PROCEDURE FOR "DOOR OUTSIDE MIRRORS" IN SECTION 10 OF THE APPROPRIATE SERVICE MANUAL. PLEASE REPLACE WITH THE NEW PROCEDURE.

ELECTROCHROMIC MIRROR FACE REPLACEMENT -

REMOVAL:

1. REMOVE MIRROR AND PLASTIC BACKING PLATE BY PULLING THE ASSEMBLY OUT OF THE MIRROR HOUSING.

2. DISCONNECT ELECTRICAL CONNECTORS.

3. REMOVE THE ACTUATOR SHAFTS SNAPPED INTO THE MIRROR HEAD BACKING.

INSTALLATION:

IMPORTANT - ENSURE SPRINGS ON ACTUATOR SHAFTS ARE NOT PUSHED DOWN ON THE SHAFTS BUT ARE SEATED IN THE GROOVE PROVIDED.

1. SNAP ACTUATOR SHAFTS INTO THE POWER DRIVE UNIT.

2. RECONNECT ELECTRICAL CONNECTORS.

3. ROTATE ACTUATOR SHAFTS TO ALIGN EARS WITH CORRESPONDING SLOTS IN THE BACK SIDE OF THE MIRROR FACE.

4. ALIGN THE SWIVEL ON THE POWER DRIVE UNIT TO THE PIVOT POINTS ON THE MIRROR BACKING PLATE.

NOTE: TO AVOID DAMAGING ELECTROCHROMIC MIRRORS, YELLOWING AND/OR SILVER DELAMINATION, PRESSURE MUST NOT BE APPLIED TO THE CENTER OF THE MIRROR. PLACE A 2 X 3 INCH BLOCK OF WOOD IN THE INDICATED TARGET AREA. THIS WILL DISTRIBUTE PRESSURE EVENLY.

5. USING THE BLOCK:

A.) PUSH IN ON BLOCK UNTIL A "SNAP" IS HEARD. B.) TILT MIRROR TOWARD UPPER ACTUATOR SHAFT AND APPLY PRESSURE ON BLOCK UNTIL RATCHET SOUND STOPS. C.) TILT MIRROR TOWARD OUTSIDE ACTUATOR SHAFT AND APPLY PRESSURE ON BLOCK UNTIL RATCHET SOUND STOPS.

6. CYCLE MIRROR FOR PROPER OPERATION. IF NOT OPERATING PROPERLY, RECHECK ACTUATOR SHAFT ALIGNMENTS.

FIGURES: 1

Object Number: 82918 Size: FS

GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.