Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the RAP System Check performed?
| --
| Go to
Step 2
| Go to
Retained Accessory Power (RAP) System Check
|
2
|
- Close all of the passenger compartment doors.
- Connect a scan tool.
- Go to the RFA Special Functions.
- Go to Outputs for RAP.
- Cycle the RAP function ON and then OFF.
Do the RAP controlled components operate?
| --
| Go to
Step 3
| Go to
Step 12
|
3
|
- Remove the RAP relay.
- Using a scan tool command the RAP system ON.
- Measure the resistance between terminal 86 and ground.
Is the resistance within the specified range?
| 0-5 ohms
| Go to
Step 5
| Go to
Step 4
|
4
| Repair open or high resistance in CKT 707.
Is the repair complete?
| --
| Go to
Retained Accessory Power (RAP) System Check
| --
|
5
|
- Using the scan tool, command the RAP system OFF.
- Measure the voltage between terminal 85 of the RAP relay
and ground.
Is the voltage within the specified range?
| 10-15 V
| Go to
Step 7
| Go to
Step 6
|
6
| Repair open in CKT 1540.
Is the repair complete?
| --
| Go to
Retained Accessory Power (RAP) System Check
| --
|
7
| Measure the voltage between terminal 87 and ground.
Is the voltage within the specified range?
| 10-15 V
| Go to
Step 8
| Go to
Step 9
|
8
|
- Remove the RADIO fuse (10A) from the IP fuse block.
- Measure the resistance between terminal 30 of the RAP relay
and the RADIO fuse terminal.
Is the resistance within the specified range?
| 0-5 ohms
| Go to
Step 10
| Go to
Step 9
|
9
| Repace the IP fuse block.
Is the repair complete?
| --
| Go to
Retained Accessory Power (RAP) System Check
| --
|
10
|
- Remove the RAP relay
- Measure the resistance from terminal 30 and 87.
Is the resistance within the specified range?
| 0-5 ohms
| Go to
Step 12
| Go to
Step 11
|
11
| Replace the RAP Relay.
Is the repair complete?
| --
| Go to
Retained Accessory Power (RAP) System Check
| --
|
12
|
- Disconnect the RFA connector.
- Connect a fused jumper between terminal 86 and a ground.
- Close all compartment doors.
- Cycle the ignition switch from RUN to OFF.
Do the RAP controlled components operate?
| --
| Go to
Step 13
| --
|
13
| Replace the RFA module. Refer to
Remote Control Door Lock Receiver Replacement
.
Is the repair complete?
| --
| Go to
Retained Accessory Power (RAP) System Check
| --
|
