Circuit Description
The EBCM/EBTCM diagnostic system check identifies problems associated with the EBCM/EBTCM. Use this system check as the starting point for any EBCM/EBTCM complaint. The check will direct you to the next logical step in diagnosing the complaint. The EBCM/EBTCM is a very reliable component and is not likely the cause of the malfunction. Most system complaints are linked to faulty wiring, connectors, and occasionally to components. Understanding the ABS system and using the tables correctly will reduce diagnostic time and prevent unnecessary parts replacement.
Diagnostic Aids
An intermittent failure in the electronic system may be very difficult to detect and accurately diagnose. The EBCM/EBTCM tests for different malfunctions under different vehicle conditions. For this reason, a thorough test drive is often needed in order to repeat a malfunction. If the system malfunction is not repeated during the test drive, a good description of the complaint may be very useful in locating an intermittent malfunction. Faulty electrical connections or wiring may be the cause of most intermitting problems. When an intermitting condition is suspected, inspect the circuits for the following conditions:
| • | Poor mating of connector halves or backed out terminals |
| • | Improperly formed or damaged terminals |
| • | Wire chafing |
| • | Poor wire to terminal connections |
| • | Dirty or corroded terminals |
| • | Damage to connector bodies |
If the DTC is a history DTC, the condition may be intermittent. Perform the tests shown while moving the related wiring and connectors. This may often cause the malfunction to occur. Perform a thorough inspection of all of the related wiring and connectors pertaining to the history DTC stored. Refer to General Electrical Diagnosis in Wiring Systems.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 |
Does the scan tool communicate with the EBCM/EBTCM? | -- | Go to Step 3 | Go to Step 2 |
2 | Does the scan tool communicate with other modules on the UART serial data line? | -- | Go to No Communication with Electronic Brake Control Module/Electronic Brake and Traction Control Module | Go to Data Link Communications System Check in Data Link Communications |
3 |
Are there any current Diagnostic Trouble Codes? | -- | Go to Diagnostic Trouble Code (DTC) List for Applicable DTC Table | Go to Step 4 |
4 | Cycle the ignition switch from the OFF to RUN position, engine off. Does the ABS Indicator turn on then turn off after several seconds? | -- | Go to Step 5 | Go to Step 7 |
5 | Is this vehicle equipped with Traction Control? | -- | Go to Step 6 | Go to Step 12 |
6 | Cycle the ignition switch from the OFF to RUN position, engine off. Does the Traction Off Indicator turn on then turn off after several seconds? | -- | Go to Step 8 | Go to Step 9 |
7 | Does the ABS Indicator stay on? | -- | Go to ABS Indicator Always On | |
8 | Is the vehicle an Oldsmobile? | -- | Go to Step 10 | Go to Step 12 |
9 | Does the Traction Off Indicator stay on? | -- | ||
10 | Cycle the ignition switch from the OFF to RUN position, engine Off. Does the Traction Active Indicator turn on then turn off after several seconds? | -- | Go to Step 12 | Go to Step 11 |
11 | Does the Traction Active Indicator stay on? | -- | ||
12 | Are there any history DTCs? | -- | Go to Step 13 | System OK |
13 |
Did the history DTC set as a current DTC while the vehicle was being driven? | -- | Go to Diagnostic Trouble Code (DTC) List for Applicable DTC Table | System OK |
