BINDING INSIDE LOCK ROD TAPE AFFECTED AREA

SUBJECT: BINDING INSIDE LOCK ROD OR INSIDE HANDLE TO LOCK ROD - TAPE AFFECTED AREA WITH CLOTH (DUCT) BODY TAPE

MODELS/YEARS: 1991 CUTLASS CIERA

CONDITION: Some 1991 Cutlass Ciera models built between vehicle number M630001 and M6339644 may exhibit a condition of binding inside lock rod or inside handle to lock rod.

CAUSE: Hot melt glue may be stuck to the inside lock rod on the back side of the water deflector as shown in the illustration.

CORRECTION: Tape over back side of water deflector in affected area with cloth body tape (duct tape) (see View B).

Procedure:

1. Remove trim panel. 2. Remove water deflector in area shown in Vie* A. 3. Remove hot melt from lock rods. 4. Tape over hot melt and reinstall water deflector. 5. Check operation of system. 6. Reinstall trim panel.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.