Circuit Description
This circuit supplies power from the body control module (BCM) to the Passlock™ sensor, CKT 1459.
Conditions for Setting the DTC
All of the following conditions must be met:
| • | The Passlock™ power is active. |
| • | The Passlock™ power CKT 1459 is open or shorted to ground for 1 second. |
Action Taken When the DTC Sets
| • | The BCM turns OFF the Passlock™ power as long as a current fault code is set. |
| • | The BCM stores DTC B2947 in the BCM memory. |
| • | The vehicle will not start or the vehicle will start but the security indicator remains illuminated. |
Conditions for Clearing the DTC
| • | The BCM goes to sleep and reinitializes with the fault cleared. |
| • | All of the BCM history codes are cleared after 100 ignition cycles (from OFF to RUN) with no current codes active during the 100 ignition cycles. |
| • | A scan tool is used. |
Diagnostic Aids
| • | When the diagnostics direct you to take electrical measurements at the junction blocks, refer to Power Distribution Schematics for terminal assignments of the wiring harness junction blocks. |
| • | If the DTC is a history DTC, the problem may be intermittent. Perform the tests shown while wiggling the wiring and connectors. This action often causes the malfunction to appear. |
Test Description
The numbers below refer to the numbers on the diagnostic table.
Step | Action | Value(s) | Yes | No | ||||
|---|---|---|---|---|---|---|---|---|
1 | Was the theft deterrent diagnostic system check performed? | -- | Go to Step 2 | |||||
Is the measured resistance equal to the specified value? | ∞ | Go to Step 4 | Go to Step 3 | |||||
3 | Repair the short to ground in CKT 1459 between the Passlock® connector terminal C and the BCM connector C3 terminal B4. Refer to Wiring Repairs in Wiring Systems Is the repair complete? | -- | Go to Step 10 | -- | ||||
4 | Inspect for a poor connection at the BCM connector C3 terminal B4, CKT 1459. Was a poor connection found? | -- | Go to Step 5 | Go to Step 6 | ||||
5 | Repair the poor connection at the BCM connector C3 terminal B4. Refer to Wiring Repairs in Wiring Systems Is the repair complete? | -- | Go to Step 10 | -- | ||||
6 | Inspect for a poor connection at the Passlock® sensor terminal C. Was a poor connection found? | -- | Go to Step 7 | Go to Step 8 | ||||
7 | Repair the poor connection at the Passlock® sensor terminal C. Refer to Wiring Repairs in Wiring Systems Is the repair complete? | -- | Go to Step 10 | -- | ||||
8 |
| -- | Go to Step 10 | Go to Step 9 | ||||
9 | Replace the BCM. Refer to the following procedures:
Is the repair complete? | -- | Go to Step 10 | -- | ||||
10 | Clear the DTCs from the memory. Is the repair complete? | -- | -- |
