GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Tools Required

J 37088-A Tool Set, Fuel Line Quick-Connect Separator

Important: Relieve the fuel system pressure before servicing any fuel system connection. Refer to Fuel Pressure Relief Procedure .

  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .

  2. Object Number: 12775  Size: SH
  3. Grasp both sides of the fitting. Twist the female connector ¼ turn in each direction to loosen any dirt within the fitting.

  4. Object Number: 12776  Size: SH

    Caution: Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.

  5. Blow dirt out of the fitting using compressed air.

  6. Object Number: 12780  Size: SH
  7. Choose the correct tool from J 37088-A Tool Set for the size of the fitting. Insert the tool into the female connector, then push inward to release the locking tabs.

  8. Object Number: 12782  Size: SH
  9. Pull the connection apart.
  10. Notice: If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.

  11. Using a clean shop towel, wipe off the male pipe end.
  12. Inspect both ends of the fitting for dirt and burrs. Clean or replace the components as required.

Installation Procedure


    Object Number: 12784  Size: SH

    Caution: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.

    This will ensure proper reconnection and prevent a possible fuel leak.

    During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.

  1. Apply a few drops of clean engine oil to the male pipe end.

  2. Object Number: 12786  Size: SH
  3. Push both sides of the fitting together to cause the retaining tabs to snap into place.

  4. Object Number: 12787  Size: SH
  5. Once installed, pull on both sides of the fitting to make sure the connection is secure.
  6. Tighten the fuel fill cap.
  7. Reconnect the negative battery cable. Refer to Battery Cable in Engine Electrical.
  8. Inspect for fuel leaks.
  9. 6.1. Turn the ignition switch ON for 2 seconds.
    6.2. Turn the ignition switch OFF for 10 seconds.
    6.3. Turn the ignition switch ON.
    6.4. Check for fuel leaks.