Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Suspension Controls Schematics | |||
1 | Did you review the Air Suspension operation and perform the necessary inspections? | Go to Step 2 | |
2 |
IMPORTANT: The vehicle must be on a drive on hoist.
Does the test lamp illuminate? | Go to Step 3 | Go to Step 6 |
3 | Connect a test lamp between the ground circuit of the Air Suspension Compressor Assembly harness and a battery positive voltage circuit. Does the test lamp illuminate? | Go to Step 4 | Go to Step 7 |
4 | Disconnect both air spring supply tubes at the Air Suspension Compressor Assembly. Did the vehicle lower? | Go to Step 5 | Go to Step 8 |
5 | Replace the Air Suspension Compressor Assembly. Refer to Air Spring Compressor Replacement . Did you complete the replacement? | Go to Step 10 | -- |
6 | Repair open circuit on the Air Suspension Compressor Assembly battery positive circuit. Did you complete the repair? | Go to Step 10 | -- |
7 | Repair open circuit on the Air Suspension Compressor Assembly ground circuit. Did you complete the repair? | Go to Step 10 | -- |
8 | Carefully inspect air tube assemble for damage. Was any damage found? | Go to Step 9 | -- |
9 | Repair or replace any damaged componets. Is the repair complete? | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | |
