Important: If you must remove more than one tube adapter at one time, stamp the BPMV with a number (1, 2 or 3) in order to indicate the number of grooves cut into the tube adapters. This procedure will aid proper reassembly.

1. Remove the appropriate brake line from the tube adapter (1).
2. Remove the tube adapter from the BPMV (3).

1. Install the new gasket (2) on the tube adapter (1).

Notice: Refer to Component Fastener Tightening Notice in the Preface section.

2. Install the new tube adapter (1) into the BPMV (3).

Tighten
Tighten the tube adapter to 31 N·m (23 lb ft).

3. Install the brake line.

Tighten
Tighten the brake line to 29 N·m (22 lb ft).

4. Bleed the system. Refer to Antilock Brake System Automated Bleed Procedure .