GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Notice: In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.

Service should normally consist of either replacement of the PCM or EEPROM re-programming.

If the diagnostic procedures call for the PCM to be replaced, the PCM should be inspected first in order to verify the PCM is the correct part. DTC P0602 indicates the EEPROM programming has malfunctioned. When DTC P0602 is set, re-program the EEPROM.

    Important: It is necessary to record the remaining engine oil life. If the replacement module is not programed with the remaining engine oil life, the engine oil life will default to 100%. If the replacement module is not programmed with the remaining engine oil life, the engine oil will need to be changed at 5000 km (3,000 mi) from the last engine oil change.

  1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
  2. Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  3. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  4. Remove the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages, and Console,

  5. Object Number: 72295  Size: SH
  6. Loosen the powertrain control module (PCM) connector screws (1).

  7. Object Number: 102470  Size: SH

    Notice: Do not touch the PCM connector pins or soldered components on the circuit board in order to prevent possible electrostatic discharge (ESD) damage. Do not remove the integrated circuit boards from the carrier.

  8. Disconnect the PCM electrical connectors.
  9. Depress the PCM retaining tabs.
  10. Slide the PCM from the PCM bracket.

Installation Procedure

Remove the new PCM from the packaging and inspect the service number to verify the number is the same number, or an updated number, as the faulty PCM.

  1. Slide the PCM into the PCM bracket.
  2. Notice: Do not touch the PCM connector pins or soldered components on the circuit board in order to prevent possible electrostatic discharge (ESD) damage. Do not remove the integrated circuit boards from the carrier.


    Object Number: 102470  Size: SH
  3. Install the PCM electrical connectors.
  4. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 72295  Size: SH
  5. Tighten the PCM connector screws (1).
  6. Tighten
    Tighten the PCM connector screws to 8 N·m (71 lb ft).

  7. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages, and Console.
  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  9. Important: : The replacement PCM must be reprogrammed and the crankshaft position system variation learn procedure must be performed.

  10. Program the PCM. Refer to Service Programming System (SPS) in Programming.
  11. The replacement PCM will NOT allow secondary air injection (AIR) pump operation until a total of 10 miles have accumulated.