GM Service Manual Online
For 1990-2009 cars only

Step

Action

Yes

No

1

Did you review the Steering Wheel and Column - Tilt Description and Operation and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Steering Wheel and Column

2

Verify that the steering column is loose.

Is the steering column loose?

Go to Step 3

System OK

3

Inspect the steering column mounting brackets for looseness.

Are the steering column mounting brackets loose?

Go to Step 8

Go to Step 4

4

Verify that the steering column bracket capsule is not sheared.

Is the steering column bracket capsule sheared?

Go to Step 9

Go to Step 5

5

Inspect the support screws for looseness.

Are the support screws loose?

Go to Step 10

Go to Step 6

6

Inspect the intermediate shaft for worn joints or looseness.

Is the intermediate joint worn or loose?

Go to Step 11

Go to Step 7

7

Inspect the tilt head, support and pivot pins for looseness.

Are there any loose components?

Go to Step 12

Go to Step 2

8

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten the brackets to specifications. Refer to Fastener Tightening Specifications .

Did you complete the repair?

Go to Step 13

--

9

Replace the jacket assembly. Refer to Steering Shaft, Lower Bearing, and Jacket - Disassemble - Off Vehicle and Steering Shaft, Lower Bearing, and Jacket - Assemble - Off Vehicle .

Did you complete the replacement?

Go to Step 13

--

10

Tighten the support screws to specifications. Refer to Fastener Tightening Specifications .

Did you complete the repair?

Go to Step 13

--

11

Tighten or replace the intermediate shaft as needed. Refer to Intermediate Steering Shaft Replacement .

Did you complete the repair?

Go to Step 13

--

12

Repair or replace the tilt head, support and pivot pins as necessary. Refer to Steering Shaft, Lower Bearing, and Jacket - Disassemble - Off Vehicle and Steering Shaft, Lower Bearing, and Jacket - Assemble - Off Vehicle .

Did you complete the replacement?

Go to Step 13

--

13

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3