Door Lock Switch Replacement Oldsmobile

1. Remove the lower pull handle bezel screws.
2. Remove the lower handle bezel.
3. Using a small flat-bladed tool, at the front of the switch bezel, push in and lift up to release the front clip.
4. Remove the front door switch bezel (1) from the front door trim panel.



5. Disconnect the electrical connectors from the power door lock switch.
6. Release the power door lock switch retainers.
7. Remove the power door lock switch from the bezel (1).

1. Install the power door lock switch to the front door switch bezel (1), pressing into place until fully seated.
2. Connect the electrical connector to the power door lock switch.
3. Install the front door switch bezel (1) to the front door trim panel.
4. Install the lower pull handle bezel, pressing into place until fully seated.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the screws to the lower switch bezel.

Tighten
Tighten the lower switch bezel trim panel screws to 10 N·m (89 lb in).

Door Lock Switch Replacement Pontiac

1. Push in and release the retaining clips (2) for the accessory switch plate (1).



2. Remove the accessory switch plate (1) from the door trim panel.
3. Disconnect the electrical connectors from the power door lock switch.



4. Release the retaining tabs for the power door lock switch.
5. Remove the power door lock switch from the accessory switch plate.

1. Install the power door lock switch to the accessory switch plate.
2. Press the power window switch into the accessory switch plate until the retaining tabs are engaged.
3. Connect the electrical connector to the power door lock switch .



4. Install the accessory switch plate (1) to the door trim panel.
5. Press the accessory switch plate (1) into the door trim panel until the retaining clips (2) are fully engaged.