For 1990-2009 cars only
Removal Procedure
- Remove the front door trim panel Insert. Refer to Front Side Door Trim Panel Insert Replacement .
- Remove the remote control from the outside rearview mirror remote control bezel (manual only). Refer to Remote Mirror Replacement .
- Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
- Disconnect the electrical connector, if power.
- Remove the front door inner panel mirror insulator (3).
- Remove the outside rearview mirror nuts (2).
- Remove the outside rearview mirror (1).
Installation Procedure
- Position the outside rearview mirror to the front door.
- Install the nuts to the outside rearview mirror (2).
- Tighten the outside rearview mirror nuts in the following order:
- Install the front door inner panel mirror insulator (3).
- Connect the electrical connector, if power.
- Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
- Install the remote control to the outside rearview mirror remote control bezel (manual only). Refer to Remote Mirror Replacement .
- Install the front door trim panel insert. Refer to Front Side Door Trim Panel Insert Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
| 3.1. | Top |
| 3.2. | Forward |
| 3.3. | Rear |
Tighten
Tighten the outside rearview mirror nuts to 10 N·m (89 lb in).
