Removal Procedure
- Remove the power steering pump (5) from the engine. Refer to Power Steering Pump Replacement .
- Remove the position retaining clip (4) from the power steering pump actuator.
- Remove the actuator (3) and discharge fitting (1) from the power steering pump (5).
- Remove and discard the actuator O-rings (2).
Important: Note the positioning of the electrical connector and discharge fitting before removal. Noted positions will be used during installation.
Installation Procedure
- Install the discharge fitting (1) and power steering pump actuator (3) with new O-rings to the power steering pump (5).
- Position the discharge fitting (1) to noted location during disassembly.
- Install the position retaining clip (4) to the actuator (3) using noted connector positioning during disassembly.
- Install the power steering pump (5) to the engine. Refer to Power Steering Pump Replacement .
- Connect the actuator (3) electrical connector.
- Perform the Diagnostic System Check - ABS in Antilock Brake System.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the actuator to 62 N·m (46 lb ft).
