GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the oil pan drain plug.
  3. Clean any metallic shavings from the magnetic drain plug. The plug is designed to isolate the metal particles from the engine oil and some accumulation is normal.

  4. Object Number: 189001  Size: SH
  5. Remove the oil filter.

Installation Procedure


    Object Number: 189001  Size: SH
  1. Install the oil filter.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the oil pan drain bolt.
  4. Tighten
    Tighten the oil pan drain bolt to 26 N·m (19 lb ft).

  5. Lower the vehicle.
  6. Fill the engine with oil to the appropriate mark.
  7. Start engine and check for leaks.
  8. Check the oil level.