GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2000 🢒 S/T Isuzu - 4WD 🢒 Body and Accessories 🢒 Body Rear End 🢒 Sheet Metal Adjustment

Aligning Sheet Metal

    Object Number: 303158 Size: SH
  1. Start alignments at the fenders where the fenders meet the front edge of the doors. Work towards the front of the vehicle.
  2. Align the rear edge of the fender to within 4-6 mm (0.16-0.24 in). Ensure that the fender is parallel to the door.
  3. Align each side of the fender to within 4-6 mm (0.16-0.24 in).
  4. You may need to adjust the front end sheet metal as a unit under the following conditions:
    5. • It is difficult to center the hood
    • The hood is out of square

Adjusting Sheet Metal as a Unit
  1. Loosen the radiator support bolts.
  2. Lightly push the sheet metal into the proper position.

    3. Tighten
    Tighten the radiator support to frame bolts to 70 N·m (52 lb ft).