GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2007 🢒 Isuzu MD F-Series 🢒 General Information 🢒 General Information 🢒 Engine Control Module Replacement/Restore Fuel Rate Data

Notice: 

   • Turn the ignition OFF when installing or removing the control module connectors and disconnecting or reconnecting the power to the control module (battery cable, powertrain control module (PCM)/engine control module (ECM)/transaxle control module (TCM) pigtail, control module fuse, jumper cables, etc.) in order to prevent internal control module damage.
   • Control module damage may result when the metal case contacts battery voltage. DO NOT contact the control module metal case with battery voltage when servicing a control module, using battery booster cables, or when charging the vehicle battery.
   • In order to prevent any possible electrostatic discharge damage to the control module, do no touch the connector pins or the soldered components on the circuit board.
   • Remove any debris from around the control module connector surfaces before servicing the control module. Inspect the control module connector gaskets when diagnosing or replacing the control module. Ensure that the gaskets are installed correctly. The gaskets prevent contaminant intrusion into the control module.
   • The replacement control module must be programmed.

Important: It is necessary to record the remaining engine oil life. If the replacement module is not programed with the remaining engine oil life, the engine oil life will default to 100 percent. If the replacement module is not programmed with the remaining engine oil life, the engine oil will need to be changed at 5 000 km (3,000 mi) from the last engine oil change.

Removal Procedure
  1. Retrieve the fuel flow rate data. Refer to Fuel Injector Flow Rate Programming .
  2. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
  3. Tilt the cab. Refer to Cab Tilting .
  4. Disconnect the electrical connector from the engine control module (ECM).

    5. Object Number: 1388293 Size: SH
  5. Remove the 6 ECM bolts and the ECM from the ECM bracket.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1388293 Size: SH
  1. Install the ECM to the ECM bracket with 6 bolts.

    2. Tighten
    Tighten the ECM retaining bolts to 25 N·m (18 lb ft).

  2. Connect the ECM electrical connector.
  3. Start the vehicle.
  4. Inspect for a proper running condition and no DTCs.
  5. Lower the cab.
  6. If a new ECM was installed, program the ECM. Refer to Control Module References .
  7. Perform the turbocharger learn procedure. Refer to Turbocharger Learn .