GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

    Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.

  1. Disable the SIR System. Refer to SIR Disabling and Enabling .
  2. Remove the instrument panel (I/P) accessory trim panel. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages, and Console.
  3. Remove the radio. Refer to Radio Replacement in Entertainment.
  4. Remove the right access cover from the I/P end cap.
  5. Remove the right air outlet. Refer to Instrument Panel Outer Air Outlet Replacement - Right Side in Heating, Ventilation, and Air Conditioning.
  6. Remove the I/P compartment door. Refer to Instrument Panel Compartment Door Replacement in Instrument Panel, Gages, and Console.
  7. Remove the digital radio receiver, if equipped. Refer to Digital Radio Receiver Replacement in Entertainment.

  8. Object Number: 1304290  Size: SH
  9. Access the 2 fasteners located above the service holes (1) inside the I/P compartment door opening.

  10. Object Number: 1304351  Size: SH
  11. Remove the fasteners from the passenger supplemental inflatable restraint (PSIR) inflator module.

  12. Object Number: 1304254  Size: SH
  13. Remove the 2 side retaining nuts (1) from the PSIR module.

  14. Object Number: 1276395  Size: SH
  15. Partially remove the PSIR inflator module from the I/P.
  16. Disconnect the connector position assurance (CPA).
  17. Disconnect the electrical connector from the PSIR module.
  18. Remove the PSIR inflator module from the vehicle.
  19. Fully deploy the module before disposal. If the module is being replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
  20. Important: If the PSIR module has deployed while attached to the I/P, the PSIR bracket MUST be replaced.

  21. If replacing the PSIR bracket, remove the I/P assembly. Refer to Instrument Panel Assembly Replacement in Instrument Panel, Gages, and Console.

  22. Object Number: 1284588  Size: SH
  23. Remove the 2 fasteners retaining the PSIR bracket to the I/P structure.

  24. Object Number: 1284589  Size: SH
  25. Remove the PSIR bracket from the vehicle.

Installation Procedure


    Object Number: 1284589  Size: SH
  1. If replacing the PSIR bracket, install the PSIR bracket to the I/P structure.
  2. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1284588  Size: SH
  3. Install the 2 fasteners retaining the PSIR bracket to the I/P structure.
  4. Tighten
    Tighten the fasteners to 9 N·m (80 lb in).

  5. Install the I/P assembly. Refer to Instrument Panel Assembly Replacement in Instrument Panel, Gages, and Console.

  6. Object Number: 1276395  Size: SH
  7. Position the PSIR inflator module to the front of the I/P and connect the electrical connector.
  8. Connect the CPA.
  9. Install the PSIR inflator module to the I/P.

  10. Object Number: 1304351  Size: SH
  11. Partially Install the 2 lower fasteners retaining the PSIR module to the I/P structure.

  12. Object Number: 1304254  Size: SH
  13. Install the 2 side retaining nuts (1) to the PSIR inflator module.
  14. Tighten
    Tighten the 4 PSIR fasteners until fully driven, seated and not stripped.

  15. Install the digital radio receiver, if equipped. Refer to Digital Radio Receiver Replacement in Entertainment.
  16. Install the radio. Refer to Radio Replacement in Entertainment.
  17. Install the I/P accessory trim panel. Refer to Instrument Panel Accessory Trim Plate Replacement in instrument Panel, Gages, and Console.
  18. Install the right air outlet. Refer to Instrument Panel Outer Air Outlet Replacement - Right Side in Heating, Ventilation, and Air Conditioning.
  19. Install the right access cover to the I/P end cap.
  20. Enable the SIR System. Refer to SIR Disabling and Enabling .
  21. Install the I/P compartment door. Refer to Instrument Panel Compartment Door Replacement in Instrument Panel, Gages, and Console.