Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC P0567: Cruise Control Resume Switch CircuitDiagnostic Fault Information
Circuit | Short to Ground | High Resistance | Open | Short to Voltage | Signal Performance |
|---|---|---|---|---|---|
B+ | 1 | 1 | 1 | -- | -- |
Cruise Control Resume/Accel. Switch Signal | 1 | -- | 1 | P0567 | -- |
Cruise Control Set/Coast Switch Signal | 1 | -- | 1 | P0568 | -- |
1. Cruise Control Malfunction | |||||
Circuit/System Description
The cruise control switch is an input to the engine control module (ECM). The ECM monitors the cruise control switch signal circuits in order to detect when a cruise control function switch has been activated. The ECM detects a voltage signal when a cruise control function switch is applied.
Conditions for Running the DTC
| • | The ignition is ON. |
| • | The cruise control switch is ON. |
Conditions for Setting the DTC
The ECM detects the resume/accel. switch is applied for greater than 90 seconds.
Actions Taken When the DTC Sets
| • | The malfunction indicator lamp (MIL) will not illuminate. |
| • | The cruise control system is disabled. |
Conditions for Clearing the DTC
| • | The condition responsible for setting the DTC no longer exists. |
| • | A history DTC will clear after 40 malfunction-free ignition cycles have occurred. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Cruise Control Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool Cruise Resume/Accel. Switch parameter while pressing and depressing the Resume/Accel. switch. The reading should change between Inactive and Active.
Circuit/System Testing
- Ignition OFF, disconnect the X4 harness connector at the turn signal/multifunction switch.
- Ignition ON, verify the scan tool Cruise Resume/Accel. Switch parameter displays Inactive.
- Install a 3A fused jumper wire between the signal circuit terminal D and the ignition circuit terminal A. Verify the scan tool Cruise Resume/Accel. Switch parameter displays Active.
- If all circuits test normal, test or replace the turn signal/multifunction switch.
| ⇒ | If not the specified value, test the signal circuit terminal D for a short to voltage. If the circuit tests normal, replace the ECM. |
| ⇒ | If not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM. |
Component Testing
- Disconnect the X4 harness connector at the turn signal/multifunction switch.
- Turn the cruise control switch ON.
- Test for infinite resistance between terminals A and D of the turn signal/multifunction switch.
- Press and hold the Resume/Accel. switch. Test for less than 1 ohm between terminal A and terminal D at the turn signal/multifunction switch.
| ⇒ | If not the specified value, replace the turn signal/multifunction switch. |
| ⇒ | If not the specified value, replace the turn signal/multifunction switch. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for ECM replacement, setup, and programming |
